Kenwood DPX-6030 Station Name Preset (SNPS)

Continue steps 3 and 4 until all the characters are chosen for

the name.

You can enter up to 8 characters for each name.

Assigning Names

Press the NAME button on the unit or the OK button on the

remote.

The name of the station is stored in memory, and the Station

Name Preset mode ends.

Also, if you make no input for 10 seconds, the name will be

stored up to the point that you have entered, and the mode

ends.

•You can assign names to up to 30 FM/AM stations in all.

•Station names remain stored even if the reset button is pressed.

•If you want to change the name of a station, first display the

name of the station (following steps 1 and 2 above), then

change the letter(s) that you want by following steps 3 and 4.

NOTE

Button to press # Times pressed

Character

#3 1

1#2

#6 2

#2 3

#3 2

“D”

“A”

“N”

“C”

“E”

— 11 —

You can assign names to radio stations with the Station Preset

Memory. Up to 30 stations can be assigned names.

Adjust the frequency to the station whose name you want to

enter.

This function cannot be available during the clock display.

Press the NAME button for at least two seconds.

“Name Set” is displayed once the station name preset mode is

entered.

The cursor will blink in the position where letters are entered.

Press either the 4or ¢button to move the cursor to the

desired position.

The 4button moves the cursor to the left, and the ¢

button to the right.

You can also move the cursor left or right by pressing the 4

or ¢buttons, respectively, on the remote.

Each time the 38button is pressed, the characters to be

entered change as listed below.

Press the FM or AM button to display the desired character.

Characters that can be displayed are as follows.

Direct Alphabet Input

(Function of remote control with number/letter entry buttons)

Direct input can be made of letters (alphabetical) with the letter

entry buttons on the remote control.

Example: Use the following table to enter the name "DANCE".

NOTE

Alphabet (upper case): _ A ~ Z

Alphabet (lower case): _ a ~ z

Numerals and symbols: _ 0~9 / + - ✽ = & " ˚ ' < > [ ]

NOTE

Station Name Preset (SNPS)