Kenwood DPX-6030

— 27 —

This mode allows you to call up the preset equalizer curves,

adjust the graphic equalizer, make the setting of the spectrum

analyzer, and so on.

Turning the Graphic Equalizer Mode On:

Press the EQ button.

"EQ CTRL" is displayed once the Graphic equalizer mode is

entered.

Be sure to turn the Graphic Equalizer mode on when performing

the operations described below in the Graphic Equalizer features.

Turning the Graphic Equalizer Mode Off:

Press the EQ button twice.

If you make no button operation for 10 seconds, the Graphic

equalizer mode is automatically canceled.

NOTE

Graphic Equalizer

You can choose the equalizer from five settings whose sound

qualities are preset to match music or vehicle characteristics.

Switching the Preset Equalizer:

Press the EQ button. "EQ CTRL" is displayed once the Graphic

equalizer mode is entered.

The preset equalizer name currently set appears in the display.

Each time you press the KBS button, the preset equalizer

switches as follows;

➨"Rock" ➨"Pops" ➨"Dance" ➨"Vocal" ➨"Flat" ➨

Press the EQ button twice to end the Graphic equalizer mode.

Preset Equalizer (KBS - Kenwood Built-in Sound) Selection

equalizer mode is entered.

The preset equalizer name currently set appears in the display.

Each time you press the 4or ¢button, the selectable

frequency band switches as follows;

"60 Hz" j"120 Hz" j"250 Hz" j"500 Hz" j"1 kHz" j"2

kHz" j"4 kHz" j"8 kHz" j"16 kHz"

Press the FM or AM button.

Press the FM button to increase the equalizer level, and the

AM button to decrease it.

There are six levels for both plus and minus allowing each band

to be set to one of 13 steps ("-12"~"+12").

Press the EQ button twice to end the Graphic equalizer mode.

Up to three graphic equalizer curves can be stored in the

memory, and then you can recall that equalizer curve with a

single touch of a button.

Press the EQ button. "EQ CTRL" is displayed once the Graphic

equalizer mode is entered.

The preset equalizer name currently set appears in the display.

Adjust the graphic equalizer curve that you want to store in the

memory.

Press the button (#1-3) that you want to use for the Graphic

Equalizer curve for at least two seconds.

"EQ MEM#" blinks once in the display to indicate that the data

has stored.

Press the EQ button twice to end the Graphic equalizer mode.

Recalling a GraphicEqualizer curve you stored:

Press the EQ button. "EQ CTRL" is displayed once the Graphic

equalizer mode is entered.

The preset equalizer name currently set appears in the display.

Press the preset button (#1-3) for the desired Graphic Equalizer

curve.

Press the EQ button twice to end the Graphic equalizer mode.

Graphic Equalizer Preset Memory

You can set the original equalizer curve which do not exist in

the preset equalizer (KBS).

Press the EQ button. "EQ CTRL" is displayed once the Graphic

Graphic Equalizer Adjustment

Graphic Equalizer features