Kenwood DPX-MP2090U manual 40

Troubleshooting Guide

HOLD:	The protective circuit in the unit activates
	when the temperature inside the
	automatic disc changer exceeds 60°C
	(140°F), stopping all operation.
	➪ Cool down the unit by opening
	the windows or turning on the air
	conditioner. As the temperature falls
	below 60°C (140°F), the disc will start
	playing again.
LOAD:	Discs are being exchanged in the Disc
	changer.
READING:	The unit is reading the data on the disc.
IN (Blink):	The CD player section is not operating
	properly.
	➪ Reinsert the CD. If the CD cannot be
	ejected or the display continues to flash
	even when the CD has been properly
	reinserted, please switch off the power
	and consult your nearest service center.
PROTECT:	The speaker wire has a short-circuit or
	touches the chassis of the vehicle, and
	then the protection function is activated.
	➪ Wire or insulate the speaker cable
	properly and press the reset button.
NA FILE:	An Audio file is played with a format that
	this unit can’t support.
	➪ ----
COPY PRO:	A copy-protected file is played.
	➪ ----
NO DVICE:	The USB device is selected as a source
	although no USB device is connected.
	➪ Change the source to any source other
	than USB. Connect an USB device, and
	change the source to USB again.
NA DVICE:	An unsupported USB device is connected.
	➪ For the supported USB devices, refer to
	<About USB device> (page 7).

NO MUSIC:
E-15:	• The connected USB device contains no
	playable audio file.
	• Media was played that doesn’t have data
	recorded that the unit can play.
	➪ Use media that has data recorded that
	the unit can play.
USB ERR:	The connected USB device is rated a
	current capacity higher than the allowable
	limit.
	➪ Check the USB device with reference to
	<About USB device> (page 7).
	Some trouble may have occurred to the
	connected USB device.
	➪ Remove the USB device and then
	reconnect it. When the same message
	displays again, use another USB device.

40 English