English | 43

Installation accessories

1

..........1

2

..........1

3

..........6

4

..........6

5

..........2

6 (DPX-U5130BT only)
3 m .....1

Installation Procedure

1 To prevent a short circuit, remove the key from the
ignition and disconnect the - battery.
2 Make the proper input and output wire
connections for each unit.
3 Connect the speaker wires of the wiring harness.
4 Connect the wiring har ness wires in the following
order: ground, battery, ignition.
5 Connect the wiring harness connector to the unit.
6 Install the unit in your car.
7 Reconnect the - battery.
8 Press the reset button.

# WARNING

• If you connect the ignition wire (red) and the battery wire
(yellow) to the car chassis (ground), you may cause a short
circuit, that in turn may start a fire. Always connect those
wires to the power source running through the fuse box.
! CAUTION
• Mounting and wiring this product requires skills and
experience. For safety’s sake, leave the mounting and wiring
work to professionals.
• Make sure to ground the unit to a negative 12V DC power
supply.
• Do not install the unit in a spot exposed to direct sunlight
or excessive heat or humidity. Also avoid places with too
much dust or the possibility of water splashing.
• Do not use your own screws. Use only the supplied screws.
Using wrong screws, could damage the unit.
• If the power is not turned ON (“PROTECT” appears), the
speaker wire may have a short-circuit or touched the chassis
of the vehicle and the protection function may have been
activated. Therefore, the speaker wire should be checked.
• If your car’s ignition key switch does not have an ACC
position, connect the ignition wires to a power source
that can be turned on and off with the ignition key. If you
connect the ignition wires to a constant-voltage power
source, as with battery wires, the battery may die.
• If the console has a lid, make sure to install the unit so that
the faceplate will not hit the lid when it is closed or opened.
• If the fuse blows, first make sure the wires are not touching
other parts to cause a short circuit, and then replace the old
fuse with one with a new the same rating.
• Insulate unconnected wires with vinyl tape or other similar
materials. To prevent a short circuit, do not remove the caps
on the ends of the unconnected wires and terminals.
• Connect the speaker wires correctly to the corresponding
terminals. The unit may be damaged or fail to work if you
share the - wires or ground them to any metal part in
the car.
• When connecting only two speakers, connect the
connectors either to both of the front output terminals
or to both of the rear output terminals (do not mix front
and rear terminals). For example, if you connect the +
connector of the left speaker to a front output terminal, do
not connect the - connector to a rear output terminal.
• After the installing the unit, check whether the brake lamps,
blinkers, wipers, etc. on the car are working properly.
• Mount the unit so that the mounting angle is 30° or less.
• Reception may become poor if there are metal objects near
the Bluetooth antenna. (DPX-U5130BT only)
Bluetooth antenna unit

For Good Reception

To assure good reception, note the following:
• Communicate with the cell-phone within the line-
of-sight distance of 10 m (30 ft). The communication
range becomes shorter depending on the surrounding
environment. The communication range also becomes
shorter when there is an obstacle between this unit and the
cell-phone. The above maximum communication range (10
m) is not always assured.
• A broadcast station or walkie-talkie located nearby can
interfere with communication due to a too strong signal.
Accessories/ Installation Procedure
13-2DIN_M_EN_00.indb 43 12/11/26 15:59