Troubleshooting guide
Problem | Possible Cause | Solution | |
|
|
| |
No power on | Power cord is not properly connected | Make sure the power cord is properly connected | |
|
|
| |
| Audio and/or digital cable is not properly connected | Make sure cable is properly connected | |
No sound |
|
| |
Incorrect input selected on receiver/controller | Select the receiver/controller input that the | ||
| |||
|
| connected to | |
|
|
| |
| Signal is weak or can’t be found | Check the Antenna Signal screen (see page 12); | |
Display reads “Acquiring Signal” |
| Change the antenna location to maximize signal quality | |
|
| ||
| Metallic window screen is interfering with reception | Move antenna to window with a | |
|
|
| |
Display reads “Antenna Error” | The antenna is not connected | Verify antenna connections | |
|
| ||
The antenna or cable is faulty | Replace antenna | ||
| |||
|
|
| |
Display reads “Call | SIRIUS subscription has not been activated | Call SIRIUS to activate your subscription | |
|
|
| |
Display reads “Invalid Channel” | Stream entered is invalid | Select a different SIRIUS stream | |
|
|
| |
|
| Turn the power off (press the POWER button), wait 5 – 10 | |
|
| seconds, then turn the power on again | |
Microprocessor error | Turn the unit’s power off, unplug the power cord from the | ||
wall outlet, wait 5 – 10 seconds, plug the power cord | |||
|
| ||
|
| back into the wall outlet and turn the power back on | |
|
| If the problem persists, consult your Kenwood dealer | |
|
|
| |
Sound mutes intermittently | Metallic window screen is interfering with reception | Move the antenna to a window with a | |
|
|
|
Specifications:
Analog Audio Output Level (1kHz) | 1.5V RMS (default), 2V (maximum) | Power Consumption | . . . . . . . . . . . . . . . . . . . . . . . 7W |
. . . . . . . . . . . . . . . . . . . . . . . >80dB | Dimensions | ||
THD + Noise (1kHz) | . . . . . . . . . . . . . . . . . . . . . . <0.05% | Weight | . . . . . . . . . . . . . . . . . . . . . . 4 lb |
Digital Audio Output | . . . . . |
|
|
13