Kenwood DT-7000S manual Installing batteries in the remote, Using the remote, Basic operation

Installing batteries in the remote

1.Remove the battery cover as shown in diagram #1 (right).

2.Install two AAA batteries as shown in diagram #2 (right).

•Observe the polarity markings on the inside of the battery compartment

3.Replace the battery cover.

Using the remote

•The supplied batteries are for operational checks, and may not last as long as alkaline batteries.

•If the remote-controllable distance begins to shorten, replace both batteries with new ones.

•Direct sunlight or light from a high-frequency fluorescent lamp may cause the remote sensor on the DT-7000S front panel to not function properly. If this happens, move the DT-7000S out of this direct light.

Activating your SIRIUS subscription

Before you can listen to the DT-7000S, you must subscribe to SIRIUS Satellite’s service.

1.Make sure that the DT-7000S is properly connected to your audio system and that the antenna is oriented to receive the SIRIUS satellite signal (see pages 4 – 5 for details)

3.Press the power button to turn the DT-7000S on. After displaying the Kenwood and SIRIUS logos, the display will read “Acquiring Signal”. Once the SIRIUS satellite signal is received, the display will change to “Call 1-888-539-SIRIUS to Subscribe”.

4.If your DT-7000S has been properly connected and the antenna is receiving the SIRIUS signal (preview stream #184) you will hear audio. If you do not hear audio, re-orient the antenna until you do. (See Antenna Signal, on page 12 to use the ANTENNA SIGNAL screen.)

•Stream # 184 is the SIRIUS preview stream. You will not be able to tune to any other streams until you activate your SIRIUS subscription.

5.Press the SETUP button to enter the Setup Mode.

6.Your unit’s unique 12-digit SIRIUS ID Number will be displayed (below). Write the number down and have your credit card handy.

7.Contact SIRIUS on the Internet at:

www.siriusradio.com. Click on the “Activate Your Subscription” link.

• You can also call SIRIUS toll-free
at 1-888-539-SIRIUS (7474). The
operator will instruct you.
8. Once your subscription has been		SIRIUS ID Screen
activated, the	display will read
“Subscription	Updated” for 3

seconds, then will revert to the Normal Operation screen.

Basic operation

After you have acti- vated your SIRIUS subscription, the Normal Operation screen will appear (right):

Use	the	CH./PRE-
SET	jog	dial	(front
panel)		or	CH

Buttons (remote) to select streams.

• The selected stream	Normal Operation Screen
will automatically play

The name and artist of the currently-playing song will scroll across the display

If you want to listen to a different entertainment category, turn the CATEGORY jog dial (front panel) or press the CAT buttons (remote) to activate the Category Select screen (right) and select entertainment categories:

1.When the category you want is highlighted, use the CH./PRESET

jog dial (front panel) or CH buttons	Category Select Screen
(remote) to highlight streams.

2.When the stream you want is highlighted, press the ENTER button to listen to the stream. The display will revert to the Normal Operation screen for that stream.

•You can switch to the previously-selected stream by holding the ENTER button for at least 1 second. Holding the ENTER button for 1 second again switches back to the original stream.

•If no streams are available in a category, or if all of the streams are set to be skipped or locked, the display will read “No Channels Available” when that category is highlighted. (See Channel Skip/Lock on pg 11.)

DT-7000S Instruction Manual

7