before using your Kenwood appliance

Read these instructions carefully and retain for future reference.

Remove all packaging and any labels.

safety

The blades and discs are very sharp, handle with care. Always hold the knife blade by the finger grip at the top, away from the cutting edge, both when handling and cleaning.

Do not lift or carry the processor by the handle - or the handle may break resulting in injury.

Always remove the knife blade before pouring contents from the bowl.

Keep hands and utensils out of the processor bowl and liquidiser jug whilst connected to the power supply.

Switch off and unplug:

before fitting or removing parts

after use

before cleaning

Never use your fingers to push food down the feed tube. Always use the pusher/s supplied.

Before removing the lid from the bowl or liquidiser or mini chopper/mill from the power unit:-

switch off;

wait until the attachment/blades have completely stopped;

be careful not to unscrew the liquidiser jug or mini chopper/mill from the blade unit.

Liquids should be allowed to cool to room temperature before blending.

Do not use the lid to operate the processor, always use the on/off speed control.

This machine will be damaged and may cause injury if the interlock mechanism is subjected to excessive force.

Never use an unauthorised attachment.

Never leave the machine on unattended.

Never use a damaged machine. Get it checked or repaired: see ‘service’.

Never let the power unit, cord or plug get wet.

Don’t let excess cord hang over the edge of a table or worktop or touch hot surfaces.

Do not exceed the maximum capacities stated.

This appliance is not intended for use by persons (including children) with reduced physical, sensory or mental capabilities, or lack of experience and knowledge, unless they have been given supervision or instruction concerning use of the appliance by a person responsible for their safety.

Children should be supervised to ensure that they do not play with the appliance.

Only use the appliance for its intended domestic use. Kenwood will not accept any liability if the appliance is subject to improper use, or failure to comply with these instructions.

Misuse of your processor/liquidiser can result in injury. before plugging in

Make sure your electricity supply is the same as the one shown on the underside of your machine.

Important – UK only

The wires in the cord are coloured as follows:

Green and Yellow = Earth, Blue = Neutral, Brown = Live.

The appliance must be protected by a 13A approved (BS1362) fuse.

WARNING: THIS APPLIANCE MUST BE EARTHED. Note:

For non-rewireable plugs the fuse cover MUST be refitted when replacing the fuse. If the fuse cover is lost then the plug must not be used until a replacement can be obtained. The correct fuse cover is identified by colour and a replacement may be obtained from your Kenwood Authorised Repairer (see Service).

If a non-rewireable plug is cut off it must be DESTROYED IMMEDIATELY.An electric shock hazard may arise if an unwanted non-rewireable plug is inadvertently inserted into a 13A socket outlet.

This appliance conforms to EC directive 2004/108/EC on Electromagnetic Compatibility and EC regulation no. 1935/2004 of 27/10/2004 on materials intended for contact with food.

before using for the first time

1Remove all packaging including the plastic blade covers from the knife blade. Take care the blades are very sharp. These covers should be discarded as they are to protect the blade during manufacture and transit only.

2Wash the parts see ‘cleaning’

3Push excess cord into the back of the machine.

key processor

￿power unit

￿detachable drive shaft

￿bowl

￿lid

￿feed tube

￿pushers

￿safety interlocks

￿cord storage

￿speed control with power on light

liquidiser

￿filler cap

￿lid

￿jug – plastic (FP910) & Glass (FP920)

￿sealing ring

￿blade unit

mini chopper/mill (FP920)

￿mill lid

￿jar

additional attachments

Not all of these attachments listed below will be included with your food processor. To buy an attachment not included in your pack, contact the dealer from whom you purchased your appliance.

￿knife blade

￿dough tool

￿twin beater geared metal whisk

￿maxi-blend canopy

thick slicing/coarse shredding disc thin slicing/fine shredding disc

fine (Julienne style) chipper disc (if supplied) rasping disc (if supplied)

geared citrus press (if supplied) mini processor bowl (if supplied) centrifugal juicer (if supplied)

KENSTORE™ attachments carousel (if supplied)

3

Page 4
Image 4
Kenwood FP920 series, FP910 series manual Safety, Key processor, Liquidiser, Mini chopper/mill FP920, Additional attachments