Installation procedure

1.Remove the ignition key and disconnect the negative - terminal of the battery to prevent short circuits.

2.Set the unit according to the intended usage.

3.Connect the input and output cables of the units.

4.Connect the speaker cables.

5.Connect the power cable, power control cable and grounding cable following this order.

6.Install the unit in the car.

7.Connect the negative - terminal of the battery.

2CAUTION

•Be sure to turn the power off before changing the setting of any switch.

•If the fuse blows, check cables for shorts, then replace the fuse with one of the same rating.

•Check that no unconnected cables or connectors are touching the car body. Do not remove caps from unconnected cables or connectors to prevent short circuits.

•Connect the speaker cables to appropriate speaker connectors separately. Sharing the negative cable of the speaker or grounding speaker cables to the metal body of the car can cause this unit to fail.

•After installation, check that the brake lamps, winkers, and wipers work properly.

Installation

Self-tapping screw (ø4 ⋅ 16 mm)

Installation board, etc. (thickness : 15 mm or more)

•Since the power amplifier has no parts which require operation, it can be installed at a position away from the driver’s seat without any hindrances.

As generally accepted positions for its installation, places such as inside the trunk, etc. can be considered.

•Use the extension cables. (Optional.)

Type

Length

0.5m

1m

2m

 

4m

 

5m

 

6m

 

RCA cable

CA-2SL

CA-12SL

CA-22SL

 

 

 

CA-52SL

 

 

 

 

 

 

 

 

 

 

RCA cable (ø7mm)

CA-3WL

CA-13WL

CA-23WL

 

 

 

CA-53WL

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

RCA cable (ø12mm)

CA-5W

CA-15W

CA-25W

CA-45W

 

 

 

CA-65W

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

2CAUTION

•Do not install the unit under the carpet. Otherwise heat build-up occurs and the unit may be damaged.

•Install this unit in a location which allows heat to easily dissipate. Once installed, do not place any object on top of the unit.

•After installing the unit, check to make sure that electrical equipment such as the brake lamps, turn signal lamps and windshield wipers operate normally.

•Install the unit securely in a location that does not interfere with driving.

3