Controls
} ~
40
p q r s | t | u v w x y z { |
NOTE
If you can’t find the specified capacity fuse at your store etc., consult your Kenwood dealer.
2Battery terminal3Ground terminal4Power control terminalControls the unit ON/OFF.
NOTE
Controls the unit power. Be sure to connect it with all the systems.
5Speaker output terminalsAs this unit accepts speakers with a minimum impedance of 1 ohm, connect speakers with
Set this control according to the
NOTE
For the
Connects the Remote cable.
NOTE
Use the Remote cable of the accessory.
!LINE IN terminal@LINE OUT terminalThe audio signal set with the LINE OUT FILTER switch will be output.
2CAUTION
The rated input of the speakers should be no less than the maximum output of the amplifier. Otherwise malfunction may result.
6ISF (infrasonic filter) switchUltralow frequencies that cannot be reproduced even by a subwoofer speaker do not become sound but become unnecessary oscillations, which affect the sound by causing distortion, etc. Setting this switch to "15 Hz" or "25 Hz" cuts the frequencies below the respective frequency.
This improves the reproduction performance of the speakers by eliminating unnecessary oscillations which will not become sound.
7This control adjusts the frequency band output from this unit.
When the power is turned on, the Power indicator lights.
If the Power indicator does not light when the power is turned on, the protection function may be activated. Check whether there is any indication of trouble. (See page 2)
$ BOOST LEVEL (Bass boost level) controlSets the level by which the low frequency range should be boosted.
%Power idndicator^FREQUENCY (Bass boost frequency) controlSets the center frequency around which the low frequency range should be boosted.
Changing over the audio signal output to the LINE OUT terminal.
ON position:The audio signal adjusted when setting LPF, INPUT SENSIVITY control and Bass boost (optional accessory) is output to the LINE OUT terminal.
OFF position:The audio signal input from the LINE IN terminal is output to the LINE OUT terminal (through output).
2CAUTION
The volume of the audio output to the LINE OUT terminal is different in ON and OFF position. Remember this when changing the LINE OUT FILTER switch from ON to OFF.
6English