Connection

WARNING

Remove the ignition key and disconnect the negative ·terminal of the battery to prevent short circuits.

CAUTION

•If sound is not output normally, immediately turn power off and check connections.

•Be sure to turn the power off before changing the setting of any switch.

•If the fuse blows, check wires for shorts, then replace the fuse with one of the same rating.

•Check that no unconnected wires or connectors are touching the car body. Do not remove caps from unconnected wires or connectors to prevent short circuits.

•Connect the speaker wires to appropriate speaker connectors separately. Sharing the negative wire of the speaker or grounding speaker wires to the metal body of the car can cause this unit to fail.

•After installation, check that the brake lamps, winkers, and wipers work properly.

*Commercially available parts

WARNING

To prevent fire caused by a short in the wiring, connect a fusible link or breaker nearby the battery’s positive terminal.

 

 

CENTER UNIT

RCA cable*

 

 

(CD receiver, etc.)

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

Power control wire*

 

 

 

 

 

 

 

Left input

Hexagon Wrench

BATT.

GND

 

L

(Small)

 

 

 

REMOTE

 

 

 

 

 

 

 

 

 

 

 

R

 

FUSE [30Ax3]

 

SPEAKER OUTPUT

 

LINE IN LINE OUT

 

Hexagon

 

Hexagon Wrench

Right input

 

Wrench

 

(Small)

 

 

(Large)

 

 

 

 

 

 

 

 

Use the

 

 

 

 

attached

Use the attached

 

 

Hexagon

 

 

Wrench.

Hexagon Wrench.

 

 

 

 

 

 

Protective Fuse*

 

 

 

 

 

Battery wire*

 

 

 

 

 

 

 

 

 

Subwoofer (L + R)

 

Terminal cover

 

 

(≥2Ω)

 

 

 

 

 

 

 

 

 

When two subwoofers are

 

 

 

 

 

connected. (≥4Ω)

Battery

Ground wire*

 

 

 

About the Lead Terminals

1. Wire Thicknesses

You can use wires with the following thicknesses:

Battery wire and ground wire

AWG 4

– AWG 6

Speaker wire

AWG 8

– AWG 12

2. Strip the wire

Make a cut in the wire sheath (insulator made from vinyl, etc.) at the position 10-13 mm away from the end of the wire, and then remove the unnecessary portion of the sheath by twisting it.

3. Install the wire

Loosen the screw using the supplied hexagon wrench. Insert the conductor of the wire in the terminal hole, and then tighten the screw.

Dual voice coil subwoofer

SPEAKER OUTPUT

(4Ω + 4Ω)

SPEAKER OUTPUT

(2Ω + 2Ω)

 

Hexagon

 

10 - 13 mm

Wrench

Hexagon Wrench

(Large)

(3/8" - 1/2")

 

(Small)

English