Troubleshooting Guide
What might appear to be a malfunction in your unit may just be the result of slight misoperation or miswiring. Before calling service, first check the following table for possible problems.
PROBLEM | POSSIBLE CAUSE | SOLUTION | |
No sound. | • | Input (or output) cables are disconnected. | • Connect the input (or output) cables. |
(No sound from one side.) | • | Protection circuit may be activated. | • Check connections by referring to <Protection function>. |
(Blown fuse.) | • Volume is too high. | • Replace the fuse and use lower volume. | |
| • The speaker cord is shorted. | • After check the speaker cord and fixing the cause of the short, | |
|
|
| replace the fuse. |
The output level is too small | • | The input sensitivity adjusting control is not set to the correct | • Adjust the control correctly referring to <Controls>. |
(or too large). |
| position. |
|
The sound quality is bad. | • The speakers wire are connected with wrong 9 / · polarity. | • Connect them properly checking the 9 / · of the terminals | |
(The sound is distorted.) |
|
| and wires well. |
| • A speaker wire is pinched by a screw in the car body. | • Connect the speaker wire again so that it is not pinched by | |
|
|
| anything. |
| • The switches may be set improperly. | • Set switches properly by referring to <System examples>. | |
The sound does not change | • The AMP CONT has been turned "OFF". | • Turn the AMP CONT "ON". | |
even when you have changed | • | The filtered band has been controlled by the Amplifier Control. | • Turn the filter Off. |
it with the Amplifier Control. |
|
|
|
The set value cannot be | • The AMP Control of the Center Unit is being used. | • Release the AMP Control mode of the Center Unit. | |
changed by the Amplifier |
|
|
|
Control of the unit. |
|
|
|
The Amplifier Control cannot | • An incorrect ID number is used for the Master amplifier. | • Always set the ID number of the Master amplifier to "0". | |
be operated from the Center | • The ID number of the amplifier has been changed. | • After you have changed the ID number of an amplifier, turn Off | |
Unit. |
|
| the POWER switch of the Center Unit first, then turn it On again. |
Specifications
Specifications subject to change without notice.
Audio Section
Max Power Output........................................................................................................................................................................................................................................ | 1000 W |
Rated Power Output (+B = 12.0 V) |
|
Normal (4 Ω) (20 Hz – 20 kHz, 0.05 % THD)................................................................................................................................................................... | 80 W × 2 |
(2 Ω) (1 kHz, 0.5 % THD) ....................................................................................................................................................................................... | 160 W × 2 |
Bridged (4 Ω) (1 kHz, 0.5 % THD) ...................................................................................................................................................................................... | 320 W × 1 |
Rated Power Output (+B = 14.4 V) |
|
Normal (4 Ω) (20 Hz – 20 kHz, 0.05 % THD)................................................................................................................................................................ | 125 W × 2 |
(2 Ω) (1 kHz, 0.5 % THD) ....................................................................................................................................................................................... | 250 W × 2 |
Bridged (4 Ω) (1 kHz, 0.5 % THD) ...................................................................................................................................................................................... | 500 W × 1 |
Sensitivity (rated output) (MAX.) ................................................................................................................................................................................................................ | 0.2 V |
(MIN.) ................................................................................................................................................................................................................. | 5.0 V |
Input Impedance ............................................................................................................................................................................................................................................... | 10 kΩ |
Low Pass Filter Frequency (24 dB/oct.) ............................................................................................................................................................... | 50 – 200 Hz (variable) |
High Pass Filter Frequency (12 dB/oct.).............................................................................................................................................................. | 50 – 200 Hz (variable) |
Infrasonic Filter Frequency (24 dB/oct.)................................................................................................................................................................................................. | 15 Hz |
Frequency Response (+0, | 5 Hz – 70 kHz |
Signal to Noise Ratio...................................................................................................................................................................................................................................... | 105 dB |
Amplifier Control Section (EQ)
Bass frequency ................................................................................................................................................................................................................. | 60 / 80 / 100 / 200 Hz |
Bass level .............................................................................................................................................................................................................................................. | |
Bass Q factor.................................................................................................................................................................................................................... | 1.00 / 1.25 / 1.50 / 2.00 |
Treble frequency ................................................................................................................................................................................................................ | 10 / 12 / 15 / 17 kHz |
Treble level .......................................................................................................................................................................................................................................... |
General
Operating Voltage .............................................................................................................................................................................................. | 14.4 V (11 – 16 | V allowable) |
Current Consumption (+B = 12.0 V, 1 kHz, 10 % THD, 4 Ω)............................................................................................................................................................ | 37 A | |
Dimensions (W × H × D) ............................................................................................................................................................................................. | 386 × 61 | × 259.5 mm |
| ||
Installation Size (W × H × D) ........................................................................................................................................................................................ | 386 × 61 × 265 mm | |
| ||
Weight ............................................................................................................................................................................................................................................. | 3.83 kg (8.44 lbs) | |
CEA-2006
RMS Power Output (+B = 14.4 V) |
|
Normal (4 Ω/2ch) (1.0 % THD+N) | ..............................................................................................................................................................................................165 W |
(2 Ω/2ch) (1.0 % THD+N) | ..............................................................................................................................................................................254 W (1 kHz) |
Bridged (4 Ω) (1.0 % THD+N).............................................................................................................................................................................................. | 505 W × 1 |
Dynamic Power (+B = 14.4 V) .................................................................................................................................................................................................................... | 170 W |
Output Regulation (+B = 14.4 V).................................................................................................................................................................................... | under 0.3 dB (4 Ω) |
Signal to Noise Ratio.................................................................................................................................................................................................................. | 81 dBA (W/4 Ω) |
(Bypass)............................................................................................................................................................................................... | 82 dBA (W/4 Ω) |
English 9