Switching the display mode.
1Select the key function section
Press the [NEXT] button.
Repeatedly press the button until "DISP" is displayed above the
[3] button.
Refer to <Notes on Multi-function Key System> (page 6).
Display Mode Switching
Fine-tuning so that the System Q value is optimal when setting
the speaker type.
1Enter Standby
Press the [SRC] button.
Select the "ALL OFF" display.
2Enter Speaker Setting mode
Press the [Q] button.
3Select the Speaker type
Press the [2] — [5] button.
Each time the button is pressed the setting switches as shown
below.
Speaker type Button Display
OFF [2] "SP OFF"
For 5 & 4 in. speaker [3] "SP 5/4inch"
For 6 & 6x9 in. speaker [4] "SP 6*9/6inch"
For the OEM speaker [5] "SP O.E.M."
4Exit Speaker Setting mode
Press the [Q] button.
Speaker Setting
3rd section
[2] button
Adjustment Item Display Range
Volume offset "V-Offset" –8 — ±0
Volume offset: Each source's volume can be set as a difference
from the basic volume.
2nd section
[2] button
Adjustment Item Display Range
Front/Rear
High Pass Filter
"HPF" Through/100/125/170 Hz
[3] button
Adjustment Item Display Range
Non-Fading "LPF NF" 50/80/120/Through Hz
Low Pass Filter
[4] button
Adjustment Item Display Range
Loudness "LOUD" ON/OFF
[5] button
Adjustment Item Display Range
Non-Fading level "NF Level" –15 — +15
•Loudness: Compensating for low and high tones during low
volume.
•When the Dual Zone System is ON, the setting for the High Pass
Filter is nullified.
General features
— 10—
English
KDC-8023_U.S 02.12.17 6:31 PM Page 10