Troubleshooting Guide

Some functions of this unit may be disabled by some settings made on this unit.

! • Cannot set up the subwoofer.

• Cannot set up the low pass filter.

• No output from the subwoofer.

▲ • <Subwoofer output> of <Function Setting> (page 8) is not set to On.

• Preout is not set to subwoofer. ☞ “SWITCH PRE” of <Function Setting> (page 8)

! Cannot set up the subwoofer Phase.

▲

Subwoofer Low Pass Filter is set to “THROUGH”. ☞

 

“LPF SUB-W” of <Function Setting> (page 8)

!Volume cannot be adjusted.

▲• The unit is set to Music Search mode. ☞ Cancel the Music Search mode. (page 11)

•The unit is set to Function Setting mode. ☞ Cancel

the Function Setting mode. (page 8)

What might seem to be a malfunction in your unit may just be the result of slight misoperation or miswiring. Before calling service, first check the following table for possible problems.

General

?The Touch Sensor Tone (beep sound) does not sound.

✔The preout jack is being used.

☞The Touch Sensor Tone cannot be output from the preout jack.

Tuner source

?Radio reception is poor.

✔ The car antenna is not extended. ☞ Pull the antenna out all the way.

Disc source

?The specified disc does not play, but another one plays instead.

✔The specified CD is quite dirty.

☞Clean the CD, referring to the CD cleaning of the section on <Handling CDs> (page 3).

✔The disc is severely scratched.

☞Try another disc instead.

Audio file source

?The sound skips when an Audio file is being played.

✔The media is scratched or dirty.

☞Clean the media, referring to the CD cleaning of the section on <Handling CDs> (page 3).

✔The recording condition is bad.

☞Record the media again or use another media.

English 17