Installation

non-Japanese cars

Metal mounting strap (commercially available)

Firewall or metal support

Bend the tabs of the mounting sleeve with a screwdriver or similar utensil and attach it in place.

Self-tapping screw (commercially available)

Screw (M4X8) (commercially available)

•Make sure that the unit is installed securely in place. If the unit is unstable, it may malfunction (for example, the sound may skip).

Japanese cars

1Refer to the section <Removing the hard rubber frame> (page 23) and then remove the hard rubber frame.

2Align the holes in the unit (two locations on each side) with the vehicle mounting bracket and secure the unit with the accessory screws.

T

 

N

N

T

T/N

 

T: Toyota cars

N: Nissan cars

8 mm

MAX.8mm MAX.

 

3

4

 

 

ø5mm

 

ø5mm

Accessory3...for Nissan car

Accessory4...for Toyota car

•During installation, do not use any screws except for those provided. The use of different screws might result in damage to the main unit.

•Damage may occur if a screwdriver or similar tool is used with excessive force during the installations.

Using the Relay Connector

1Plug the vehicle’s harness into the relay connector.

2Plug the parking brake detection wire into the relay connector.

Vehicle harness

 

Relay connector

 

2

Accessory7

 

 

1

Detection wire

3Lock the cable clamp.

Cable clamp

3

4Press down using pliers until the conductive metal is even with the plastic surface.

5Lock the lid.

Lid

5

4

Conductive metal

English 21