Adjustment Item

Display

Range

Front High Pass Filter*2

"HPF"

Through/40/60/80/100/120/

 

 

150/180/220 Hz

Rear High Pass Filter*2

"HPR"

Through/40/60/80/100/120/

 

 

150/180/220 Hz

Low Pass Filter*1,2

"LPF"

50/60/80/100/120/

 

 

Through Hz

Subwoofer Phase*1,2,3

"PHAS"

Reverse (180°)/ Normal (0°)

Volume offset

"V-OFF"

–8 — ±0

Loudness

"LOUD"

OFF/ON

Dual Zone System

"2ZON"

OFF/ON

•Volume offset: Sets each source’s volume as a difference from the basic volume.

•Loudness: Compensates for low and high tones during low volume.

When Loudness is ON, "LOUD" indicator is ON.

•*1 You can control this item when <Subwoofer Output> (page 12) is set to "SW ON".

•*2 You can control this item when "2ZON" of <Audio Setup> (page 10) is set to "OFF".

•*3 You can control this item when Low Pass Filter is not set to Through.

•Dual Zone System

Main source and sub source (Auxiliary input) output Front channel and Rear channel separately.

-Set up the channel of sub source by <Dual Zone System Setting> (page 24).

-Select Main source by [SRC] button.

-Adjust the volume of Front channel by [VOL] knob.

-Adjust the volume of Rear channel by <Audio Control> (page 10).

-The Audio Control has no effect on sub source.

•You can use the Dual Zone System with the Auxiliary input sources listed below.

-Option CA-C1AX/ CA-C2AX

5Exit Audio Setup modePress the [VOL] knob for at least 1 second.

Speaker Setting

Fine-tuning so that the System Q value is optimal when setting the speaker type.

1Enter Standby

Press the [SRC] button. Select the "STANDBY" display.

2Enter Speaker Setting mode Press the [VOL] knob.3Select the Speaker type Turn the [VOL] knob.

Each time you turn the knob, the setting alternates between the settings shown in the table below.

Speaker type

Display

OFF

 

"SP OFF"

For 5

& 4 in. speaker

"SP 5/4"

For 6

& 6x9 in. speaker

"SP 6x9/6"

For the OEM speaker

"SP OEM"

4Exit Speaker Setting mode Press the [VOL] knob.

English 11