Kenwood KDC-MP5032 Audio Preset Memory, Audio Preset Recall, Demonstration mode Setting, Display, Setting, Exit Menu mode, Enter Menu mode, 7Exit Menu mode, Enter Menu mode

Menu system

Other than Standby mode

Audio Preset Memory

Registering the value setup by Sound Control. The memory cannot be erased by the Reset button.

1Setup Sound Control

Refer to the following operations to setup the Sound Control.

-<Audio Control> (page 10)

-<Audio Setup> (page 10)

2Enter Menu mode

Press the [MENU] button for at least 1 second. "MENU" is displayed.

3Select Audio Preset modePush the Control knob towards [FM] or [AM]. Select the "A- PRESET" display.4Enter Audio Preset modePress the Control knob for at least 1 second.5Select the Audio Preset MemoryPush the Control knob towards [FM] or [AM]. Select the "MEMORY" display.6Put the Audio Preset in the memory

Press the Control knob for at least 2 seconds. The "MEMORY" display blinks 1 time.

7Exit Menu mode

Press the [MENU] button.

• Register 1 pair of Audio Preset Memory. You cannot register by the source.

• When you press the Reset, all the sources will be the setting value which is registered.

• The following items cannot be registered.

Volume, Balance, Fader, Loudness, Volume offset, Dual Zone System, Rear Volume

Other than Standby mode

Audio Preset Recall

Recalling the sound setup registered by <Audio Preset Memory> (page 26).

1Select the source Press the [SRC] button.

2Enter Menu mode

Press the [MENU] button for at least 1 second. "MENU" is displayed.

26 English

3Select Audio Preset mode

Push the Control knob towards [FM] or [AM]. Select the "A- PRESET" display.

4Enter Audio Preset mode

Press the Control knob for at least 1 second.

5Select the Audio Preset RecallPush the Control knob towards [FM] or [AM]. Select the "RECALL" display.6Recall the Audio Preset

Press the Control knob for at least 2 seconds. The "RECALL" display blinks 1 time.

7Exit Menu mode

Press the [MENU] button.

•The User memory of <System Q> (page 10) is changed to the value which was recalled.

•The source tone memory item of <Audio Control> (page 10) is changed to the value which was recalled by the selected source.

In Standby mode

Demonstration mode Setting

Sets the demonstration mode.

1Select the Demonstration modePush the Control knob towards [FM] or [AM]. Select the "DEMO" display.2Set the Demonstration mode

Press the Control knob for at least 2 seconds. Each time you press the knob at least 2 seconds, the Demonstration mode alternates between the settings shown in the table below.

Display	Setting
"DEMO ON"	The Demonstration mode function is ON.
"DEMO OFF"	Exit Demonstration mode (Normal mode).