Getting started

Canceling the display demonstration

The display demonstration is always turned on unless you cancel it.

When you turn on the power (or after you reset the unit), the display shows:

[CANCEL DEMO] \ [PRESS] \

[VOLUME KNOB]

1Press the volume knob.

[YES] is selected as the initial setup.

2Press the volume knob again to confirm. [DEMO OFF] appears.

If no operation is done for about

15 seconds or if you turn the volume knob to select [NO] in step 2, [DEMO MODE] appears and the display demonstration starts.

Setting the demonstration mode

1Press the volume knob to enter [FUNCTION].

2Turn the volume knob to select [DEMO MODE], then press to enter.

3Turn the volume knob to select [ON] or

[OFF].

If [ON] is selected, display demonstration starts if no operation is done for about 20 seconds.

4Hold to finish the procedure.

Adjusting the clock

1Press the volume knob to enter [FUNCTION] mode.

2Turn the volume knob to select [SETTINGS], then press to enter.

3Turn the volume knob to select [CLOCK], then press to enter.

4Turn the volume knob to select [CLOCK ADJUST/ CLOCK ADJ], then press to enter.

Clock hour flashes on the display.

5Turn the volume knob to adjust the hour, then press to enter the minute adjustment.

Clock minutes flashes on the display.

6Turn the volume knob to adjust the minute, then press to confirm.

Press 4 / ¢ to move between the hour and minute adjustment.

7Hold to finish the procedure.

Initial settings before operations

1Press SRC to enter [STANDBY] mode.

2 Press the volume knob to enter [FUNCTION] mode.

3 Turn the volume knob to select [INITIAL SET], then press to enter.

4 Turn the volume knob to make a selection, then press to confirm. See table on page 7 for selection.

5 Hold to finish the procedure.

Maintenance

Cleaning the unit: Wipe off the dirt on the panel with a dry silicon or soft cloth. Failure to observe this precaution may result in damage to the monitor or unit.

Cleaning the connector: Wipe off dirt on the connector of the unit and faceplate. Use a cotton swab or cloth.

Handling discs

Do not touch the recording surface of the disc.

Do not stick tape etc. on the disc, or use a disc with tape stuck on it.

Do not use any accessories for the disc.

Clean from the center of the disc and move outward.

Clean the disc with a dry silicon or soft cloth. Do not use any solvents.

When removing discs from this unit, pull them out horizontally.

Remove the rims from the center hole and disc edge before inserting a disc.

6