Tuner features

English

Auto Memory Entry

You can automatically store all the receivable frequencies in the band currently being listened to, and then recall them with the touch of a button later. This function is especially useful when you are travelling and do not know what stations are available. Up to six frequencies can be stored this way.

1Select the band for auto memory entry.

2Press the AME button for at least two seconds to start auto memory entry.

The numbers of the preset station buttons are shown in order. When all the stations in a certain band are stored in the preset memory, the auto memory entry stops. The tuner then plays the last station received.

Recalling a Preset Station:

Press the preset station button (#1-6) for the desired station. The number of the recalled station is displayed.

The 4 button moves the cursor to the left, and the ¢ button to the right.

You can also move the cursor left or right by pressing the 4 or ¢ buttons, respectively, on the remote.

4Each time the 38 button is pressed, the characters to be entered change as listed below.

Press the FM or AM button to display the desired character. Characters that can be displayed are as follows.

Alphabet (upper case): A ~ Z

Alphabet (lower case): a ~ z

Numerals and symbols: 0~9 @ ” ‘ ` % & + - = , . / \ < > [ ]

Special characters: á à é è í ì ó ò ú ù Ñ Ç ® ß ‹ fl â ä ê ë î ï ô ö û ü ñ ç © Æ › fi

Station Name Preset (SNPS)

You can assign names to radio stations with the Station Preset Memory. Up to 32 FM stations and 16 AM stations can be assigned names.

1Adjust the frequency to the station whose name you want to enter.

NOTE

When full-screen display has been selected for the display mode and the upper part display of the vertical division display is the program service name or radio text, the station name preset function cannot be used.

2Press the NAME.S button for at least two seconds.

"NAME SET" is displayed once the station name preset mode is entered.

The cursor will blink in the position where letters are entered.

3Press either the 4 or ¢ button to move the cursor to the desired position.

NOTE Direct Alphabet Input (KDC-X915/X815 only)

Direct input can be made of letters (alphabetical) with the letter entry buttons on the remote.

Example: Use the following table to enter the name "DANCE".

Character

Button to press

# Times pressed

 

 

 

“D”

#3

1

“A”

#2

1

“N”

#6

2

“C”

#2

3

 

 

 

“E”

#3

2

5Continue steps 3 and 4 until all the characters are chosen for the name.

NOTE

You can enter up to 8 characters for each name.

6Assigning Names

Press the NAME.S button on the unit or the OK button on the

— 18 —