IMPORTANT!
DO NOT DISCARD THE SHIP KIT LOCATED ON TOP OF THE DECK AND BELT. ALL NECESSARY COMPONENTS NEEDED TO COMPLETE THE INSTALLATION ARE LOCATED IN THE SHIP KIT.
NE JETEZ PAS LE KIT D'EXPÉDITION PLACÉ SUR LE DESSUS DU PLATEAU ET SUR LE TAPIS. IL CONTIENT TOUS LES ÉLÉMENTS NÉCESSAIRES POUR L'INSTALLATION.
IMPORTANT!
Check the belt edge under the treadmill to verify the belt does not interfere with lifespring brackets and the belt is properly set within the belt guides.
1. Remove the four SCREwS (A) securing the FRONT GRILL (B) to the FRAME (C). Remove the FRONT GRILL and set it aside.
2. Remove the four SCREwS (D) securing the MOTOR COvER (E). Lift and remove the MOTOR COvER and set it aside.
3. Locate the LEFT UPRIGHT (1). Lay the LEFT UPRIGHT across the belt and deck with the notched end near the LEFT UPRIGHT
MOUNTING BRACKET (F).
4. Unwrap the MAIN wIRE HARNESS (G) leading from the LEFT
UPRIGHT MOUNTING BRACKET (F). Feed the MAIN wIRE
HARNESS through the LEFT UPRIGHT (1). Carefully tilt the LEFT
UPRIGHT upwards and position the notched end of the LEFT
UPRIGHT over the LEFT UPRIGHT MOUNTING BRACKET. with the
LEFT TOP MOUNTING PLATE (H) directed forward, slide the
LEFT UPRIGHT down over the LEFT UPRIGHT MOUNTING
BRACKET and
Note: Be careful not to damage the Main Wire Harness (G) when routing it through the Left UpriGHt (1) or when
sliding the Left UpriGHt over the Left UpriGHt MoUntinG Bracket (f).
Note: Be sure the
5. Locate the RIGHT UPRIGHT (2). with the RIGHT TOP MOUNTING PLATE (J) directed forward, slide the RIGHT UPRIGHT down
over the RIGHT UPRIGHT MOUNTING BRACKET (K) and pre-
installed BOLT and wASHER until it rests on the fraMe (C).
Secure the RIGHT UPRIGHT to the RIGHT UPRIGHT MOUNTING
BRACKET using two BOLTS and wASHERS (20 & 24). Use one BOLT and wASHER on the inside of the RIGHT UPRIGHT and one BOLT and wASHER on the front side of the RIGHT UPRIGHT. Leave the BOLTS loose at this time.
Note: Be sure the pre-installed washer is on the outside
of the RIGHT UPRIGHT (2) when sliding it down to rest on the fraMe (c).
4