Life Fitness CLST, 97Ti manual Tighten all UPRIGHT BOLTS securely

16. Locate the LEFT ACCESSORY TRAY (11). Carefully slide the tray into the top of the LEFT UPRIGHT (1) as shown until fully seated. Secure the accessory tray to the LEFT TOP MOUNTING PLATE (H) using four SCREWS (21). Repeat the procedure for the RIGHT

ACCESSORY TRAY (12) and RIGHT TOP MOUNTING PLATE (J).

17. Tighten all UPRIGHT BOLTS securely.

18. Replace the MOTOR COVER (E) and secure the MOTOR COVER to the FRAME (C) using the four previously removed SCREWS

(D). Tighten the SCREWS securely. Do not overtighten the

SCREWS.

19.Replace the FRONT GRILL (B) and secure the FRONT GRILL to the

FRAME (C) using the four previously removed SCREWS (A).

Tighten the SCREWS securely. Do not overtighten the SCREWS.

20. Locate one SCREW GROMMET (18). Insert the SCREW GROMMET into the square hole located above the top inside mounting bolt of the RIGHT UPRIGHT (2). Repeat for the remaining SCREW

GROMMET and LEFT UPRIGHT (1).

21. Locate one LOWER UPRIGHT COVER (10). Position the LOWER UPRIGHT COVER at the bottom notch of the RIGHT UPRIGHT (2) making sure the top lip of the UPRIGHT COVER is engaged under the outside notch of the RIGHT UPRIGHT. Secure the UPRIGHT COVER to the RIGHT UPRIGHT using one SCREW (16). Tighten the SCREW securely. Do not overtighten the SCREW. Repeat the pro cedure for the LEFT UPRIGHT (1) and remaining UPRIGHT COVER.

22. Locate the UPRIGHT PLUGS (25). Insert one UPRIGHT PLUG into each of the two access holes located on the lower outside of the

LEFT and RIGHT UPRIGHTS (1 & 2).

23. Locate and press the HANDLEBAR CAPS (13) over the ends of the HANDLEBARS (3). Be sure the HANDLEBAR CAPS are fully seated.

24.Using two SCREWS (16) each, attach the two REAR FRAME END CAPS (14) to the FRAME (C) as shown. Tighten the SCREWS

securely. Do not overtighten the SCREWS.

25. The treadmill striding belt must be “walked-in” for five minutes after assembly is complete.

Plug the treadmill into an appropriate outlet. Turn the treadmill on at the on/off switch. Select QUICK START from the console. Increase the speed to 3 mph (4.8 km/h). Start walking in the front left corner of the walking surface and drift to the back, move to the center of the deck and walk towards the front, and finally walking to the right corner and drifting to the back. Continue pattern for five minutes.

26. Refer to the specific treadmill’s Operation Manual for power requirements, proper line cord routing, and other critical product information before connecting the treadmill to a power source

7