Life Fitness 97Ti, CLST manual Note Be careful not to pinch any cables when assembling

Models: 97Ti

1 9
Download 9 pages 52.73 Kb
Page 7
Image 7
Note: Be careful not to pinch any cables when assembling

12.Slide the LEFT INSIDE HANDLEBAR SHROUD (5) near the LEFT UPRIGHT HANDLEBAR BRACKET (N).

Position the HANDLEBAR GROMMET (27) at the end of the LEFT

INSIDE HANDLEBAR SHROUD. Install the HANDLEBAR GROMMET onto

the inside edge of the LEFT INSIDE HANDLEBAR SHROUD as shown.

Locate and position the LEFT OUTSIDE HANDLEBAR SHROUD (7) to

match the LEFT INSIDE HANDLEBAR SHROUD.

Install the remaining portion of the HANDLEBAR GROMMET onto the LEFT OUTSIDE HANDLEBAR SHROUD as it is positioned to match the

LEFT INSIDE HANDLEBAR SHROUD.

Secure the SHROUDS together using three SCREwS (15). Tighten the SCREwS securely. Do not overtighten the SCREwS. Repeat the

procedure for the RIGHT INSIDE and OUTSIDE HANDLEBAR SHROUDS

(6 & 8).

13. Locate the DISPLAY CONSOLE (9). Remove the eight SCREwS (P) from the back of the DISPLAY CONSOLE and separate the front of the DISPLAY CONSOLE from the rear. Position the REAR CONSOLE

(Q) over the LEFT and RIGHT TOP MOUNTING PLATES (H & J) as shown. From the bottom of the LEFT and RIGHT TOP MOUNTING PLATES, secure the REAR CONSOLE using four SCREwS (17).

Tighten the SCREwS securely. Do not overtighten the SCREwS.

14.Position and rest the FRONT CONSOLE (R) face down across the HANDLEBARS (3). Connect all CONNECTORS leading from the LEFT (if equipped) and RIGHT UPRIGHTS (1 & 2) to the corresponding CONNECTORS located on the FRONT CONSOLE. Feed any excess wIRE HARNESS into the UPRIGHTS. Carefully route all wIRE HARNESSES through the wIRE HARNESS GUIDES (S) located at the lower left of the REAR CONSOLE (Q).

Note: consoles for the european Union countries are equipped with a FERRITE (t). open the FERRITE (t). route the Main Wire Harness (G) through the FERRITE. close the FERRITE.

15.Tilt the FRONT CONSOLE (R) upright and in position over the REAR CONSOLE (Q). Secure the FRONT CONSOLE to the REAR using the previously removed eight SCREwS (P). Tighten the SCREwS securely. Do not overtighten the SCREwS.

Note: Be careful not to pinch any cables when assembling

the FRONT CONSOLE (r) to the REAR CONSOLE (q).

R

Q

P

S

Q

1

T

G

 

6

Page 7
Image 7
Life Fitness 97Ti, CLST manual Note Be careful not to pinch any cables when assembling