6.Locate both HANDLEBARS (3). Slide one HANDLEBAR GROMMET (27) over each HANDLEBAR. The groove of the HANDLEBAR GROMMET should face outward.
7.with the bend of one HANDLEBAR (3) directed to the outside of the treadmill, insert the HANDLEBAR into the RIGHT UPRIGHT HANDLEBAR BRACKET (L) as shown. Be sure the handlebar mounting holes are aligned. Repeat for the left side HANDLEBAR.
8.Locate the ERGO™ FRONT CROSSBAR (4) and position the ERGO FRONT CROSSBAR with the plastic COvER (M) facing upward and forward as shown. Locate and slide the LEFT and RIGHT INSIDE SHROUDS (5 & 6) over the corresponding ends of the ERGO FRONT
CROSSBAR as shown. Slide the LEFT and RIGHT INSIDE HANDLEBAR
SHROUDS towards the center of the ERGO FRONT CROSSBAR as shown. Note: Be careful not to damage any wire harnesses that may be leading from the ends of the ERGO FRONT CROSSBAR (4).
M 6 26
5
26
19 |
4
O |
N
| 22 | 2 |
|
| |
1 |
| 3 |
| 17 | |
|
|
L | 22 |
3
17
9.Install one FRONT CROSSBAR GROMMET (26), rounded end first, over either end of the ERGO FRONT CROSSBAR (4). Position the grommets just over the end brackets to meet the overmolding.
Note: Be careful not to damage any wire harnesses that may be leading from the ends of the ERGO FRONT CROSSBAR (4).
10.Position the right end of the ERGO FRONT CROSSBAR (4) near the large access hole on the inside of the RIGHT UPRIGHT HANDLEBAR
BRACKET (L). Align the ERGO FRONT CROSSBAR MOUNTING HOLES
with those in the RIGHT UPRIGHT HANDLEBAR BRACKET and secure using two BOLTS (19), from the inside of the treadmill, and NUTS (22). Tighten the BOLTS securely. Insert one SCREw (17) from
under the RIGHT UPRIGHT HANDLEBAR BRACKET. Tighten the SCREw
securely.
11.Position the left end of the ERGO FRONT CROSSBAR (4) near the large access hole on the inside of the LEFT UPRIGHT HANDLEBAR BRACKET (N). Feed the HEART RATE CABLE (O) into the access hole downward out the bottom of the LEFT UPRIGHT HANDLEBAR
BRACKET.
Align the crossbar mounting holes with those in the LEFT UPRIGHT HANDLEBAR BRACKET and secure using two BOLTS (19), from the inside of the treadmill, and NUTS (22). Tighten the BOLTS securely. Insert one SCREw (17) from under the LEFT UPRIGHT HANDLEBAR BRACKET. Tighten the SCREw securely.
Note: the cLst model does not have an activity Zone on the ergo™ front crossbar.
Note: Be careful not to pinch the HEART RATE CABLE (o) (if equipped) when assembling the ERGO FRONT CROSSBAR
(4)to the LEFT UPRIGHT HANDLEBAR BRACKET.
Feed the HEART RATE CABLE (O) upward through the top of the
LEFT UPRIGHT (1).
5
