Static Addressing, Addressing DHCP, BOOTP, or Rarp

Static Addressing

NOTE	Your Document Centre now has DHCP, LPR, and NetBIOS over
	the IP protocol enabled by default. If you have a DHCP server and
	it is set to provide host name, IP address, Gateway address, and
	Subnet Mask, the Document Centre TCP/IP information will be
	configured on initial boot. This procedure assumes you will set the
	IP information manually.

	To enable 100BaseT or a Token Ring interface, refer to Chapter 2
	How to Connect to Ethernet or Token Ring Networks to
	configure the Speed and Source Routing settings for your
	environment.
	For information on how your printer can connect to a DHCP,
	BOOTP, or a RARP server to be assigned an IP address
	dynamically, refer to the section in this chapter entitled Dynamic
	Addressing (DHCP, BOOTP, or RARP).

Page 3 - 6