Xerox 480 ST, 490 ST manual Novell NetWare 3.1x or 4.x/5.x in Bindery Mode

6.Novell NetWare 3.1x or 4.x/5.x in Bindery Mode

Before you start

To enable 100BaseT or a Token Ring interface, refer to

Chapter 2 How to Connect to Ethernet or Token Ring

Networks section to configure the Ring Speed and Source Routing settings for your environment.

The CentreWare software supplied with your printer can be used to set up your printer on your Novell network. For details refer to the document entitled CentreWare Network Services Guide. This procedure assumes you ran PCONSOLE to set up a print server. Please refer to the documentation supplied by Novell to complete this task. Record precisely (observe upper and lower case, punctuation etc.) the following: the Primary Server name, Frame type used, Print Server name, Print Server password, and the Queue name assigned.

3.1x or	Mode
6. Novell NetWare	4.x/5.x in Bindery

Xerox Document Centre System Administration Guide Page 6 - 1