Go to the Document Centre and...

NOTE

This procedure assumes that any TCP/IP components necessary for

 

network installation have already been assigned to the Document

 

Centre. If these components have not been configured, please refer

 

to the appropriate information contained within the section entitled

 

Dynamic/Static IP Addresses & WINS before continuing further.

 

 

Connect your Document Centre to the network with the

 

 

appropriate cabling.

 

 

1.

Enter the Tools pathway.

 

 

 

a) Press the Access ( or

) button.

b) On the keypad enter 1111 or the current password. Press the Enter button when finished. The Touch Screen will be used for the remainder of the data entry, unless instructed otherwise.

c)Press the Go to Tools button.

2.Enter the Network Setup menus.

a)Wait for the screen to refresh and press the Connectivity and Network Setup button.

b)Wait for the screen to refresh and press the Network Setup button.

3.Enable Microsoft Networking.

a)Press the Microsoft Networks button.

b)At the next screen, press the Transport and Media button.

c)Press the Enable button to enable the Microsoft Network protocols.

d)If Physical Media buttons appear, press the corresponding button to select either IP/Ethernet, or IP/Token Ring. After making your selection press Save.

e)Press the Workgroup and Host button.

Microsoft (TCP/IP)

Networks

9.

 

 

 

Xerox Document Centre System Administration Guide

Page 9 - 3

Page 71
Image 71
Xerox 480 ST, 490 ST manual Go to the Document Centre