Xerox 480 ST, 490 ST manual Rom

Go to a workstation and...

NOTE	This procedure assumes that any TCP/IP components necessary for
	network installation have already been assigned to the Document
	Centre. If these components have not been configured, please refer
	to the appropriate information contained within the section entitled
	Dynamic/Static IP Addresses & WINS before continuing further.
	1.	Create a new printer and load print drivers from the CD-
		ROM.
	2.	Create a printer share and its access permissions (sharing and
		connecting).
	3.	Start LPRPORTD/LPRMON, ping printer, open EPM and
		send a print job to the printer.
	4.	Check your test job for quality and use the problem solving
		section of the Document Centre Reference Guide for
		resolving print defects.
	5.	If your print job does not print, refer to the Troubleshooting
		section in this document to correct the problem.
	6.	Repeat this Go to a workstation and... procedure at each
		workstation that will print to this printer.

OS/2 (TCP/IP)	Networks
12.

Xerox Document Centre System Administration Guide Page 12 - 3