Go to a workstation and...

1.Create a test job and send it to the printer with a workstation utility, or through a queue on your operating system that sup- ports Port 9100 printing.

2.Check your test job for quality and use the problem solving section of the Document Centre Reference Guide for resolving print defects.

3.If your print job does not print, refer to the troubleshooting section in this document entitled TCP/IP Troubleshooting to correct the problem.

4.Repeat this Go to a workstation and... procedure at each workstation that will print to this printer, or at other servers where the queue was created.

Page 22 - 6

Xerox Document Centre System Administration Guide

Page 312
Image 312
Xerox 490 ST, 480 ST manual Go to a workstation