Xerox 480 ST, 490 ST manual How to set the Hardware MAC Address

How to set the Hardware (MAC) Address

All Document Centre printers equipped with a Token Ring interface have a default MAC address. It is STRONGLY recommended that you use caution when changing the MAC Address of the network interface.

1.Access the Tools pathway.

a) Press the Access ( or ) button.

b) On the keypad enter 1111 or the current password. Press the Enter button when finished. The Touch Screen will be used for the remainder of the data entry, unless instructed otherwise.

c)Press the Go to Tools button.

2.Set or Change the MAC address.

a)Wait for the screen to refresh and press the Connectivity and Network Setup button.

b)Wait for the screen to refresh and press the Physical Media button.

c)Press the Token Ring button.

d)Press the Token Ring Settings button.

e)Press the MAC Address button.

f)Enter the six (6) hexadecimal pairs on the touch keypad separated by colons.

g)When finished press Save.

h)Press the Exit Tools button.

3.Wait a MINIMUM of 7 minutes for the printer to reset. The Network Controller is being reset and initializing with the new setup. When complete a Configuration Report will print.

a)Obtain the Configuration Report page from your printer and verify that your Token Ring Settings have been retained.

4.Connect your Document Centre to the network with the appropriate cabling.

Connect to	Token Ring
2. How to	Ethernet or

Xerox Document Centre System Administration Guide Page 2 - 5