Xerox 490 ST, 480 ST manual Windows Internet Name Service Wins Installation, Before You Start

Windows Internet Name Service (WINS) Installation

	Before You Start
	If your printer is equipped with a Token Ring interface, use the
	100BaseT Ethernet or Token Ring Quick Install Card supplied
	in this Quick Install Card set to configure the Ring Speed and
	Source Routing settings for your environment.
	Your Document Centre now has DHCP, LPR, and NetBIOS over
	the IP protocol enabled by default. If your DHCP server will
	provide the IP address, Gateway address, Subnet Mask for the
	Document Centre, and WINS server address(es), the TCP/IP
	information will be configured on initial boot. This means that if
	you have configured your DHCP server with the desired
	information, you may connect your Document Centre to your
	network and it will boot and register with the WINS server
	automatically.
NOTE
	Your DHCP server must return at least one (1) WINS server
	address to the Document Centre in order to enables WINS
	registration.
	In this mode the default NetBIOS host name, SMB host name and
	the DNS host name for the device will be the letters XRX followed
	by the MAC address of the network interface.
	Example:
	XRX08003E313E0A
	If this NetBIOS host name is acceptable you can go right to the
	section in the next section entitled Go to the Workstation and....
	and complete those steps.
	To change the NetBIOS host name for your printer follow Steps 1,
	2, and 3 then skip to Step 5 and finish the Go to the Document
	Centre... portion. When you finish that section, go to the section
	entitled Go to the Workstation and.... and complete those steps.

Page 3 - 10 Xerox Document Centre System Administration Guide