Xerox 490 ST, 480 ST manual FAX Installation for FTP, Before You Start

FAX Installation for FTP

	Before You Start
NOTE
	Your Document Centre now has DHCP, LPR, and NetBIOS over
	the IP protocol enabled by default. If your DHCP server will
	provide host name, IP address, Gateway address, and Subnet Mask,
	the Document Centre TCP/IP information will be configured on
	initial boot.
	Your Document Centre and your network Fax Server/software
	solution must be connected to a network which has the TCP/IP
	protocol enabled. Additionally, record TCP/IP information such as
	Hostname, TCP/IP Address, and Default Gateway for both the
	network Fax Server solution and your Document Centre.
	It is strongly recommended your network Fax Server is assigned a
	static IP address. If necessary, refer to the Static (Manual)
	TCP/IP Addressing Quick Install Card contained in this card set
	to configure your Document Centre in this manner.
	Dynamic IP Addressing may be used for the network Fax
	Server/software solution provided the DHCP server has been
	configured with sufficient lease time so that the server normal
	maintenance and service down times will not result in a change in
	TCP/IP address.
	An account must be created on the server to which the Document
	Centre will FTP the fax documents that has sufficient rights or
	permissions to allow the Document Centre to read files, write files,
	delete files, and create new directories. Anonymous FTP logins will
	not allow these rights. Record the login name, home directory, and
	password of this account for use during this procedure.

Page 19 - 2 Xerox Document Centre System Administration Guide