Xerox 490 ST, 480 ST manual Before You Start

Before You Start

To enable 100BaseT or a Token Ring interface, refer to Chapter 2

How to Connect to Ethernet or Token Ring Networks to

configure the Speed and Source Routing settings for your environment. Then return here and perform this prodecure.

For Dynamic TCP/IP Addressing, use the DHCP, BOOTP, or RARP Instructions found in this document in the section entitled Dynamic/Static TCP/IP Addresses and WINS to connect it to the appropriate server then return here to complete the setup.

Record the following information assigned to your Document Centre:

IP Address ____________________________

Subnet Mask ___________________________

Default Gateway ________________________

Page 22 - 2 Xerox Document Centre System Administration Guide