Xerox 480 ST, 490 ST manual 12. OS/2 TCP/IP Networks, Before You Start

12. OS/2 (TCP/IP) Networks

Before You Start

	To enable 100BaseT or a Token Ring interface, refer to Chapter 2
	How to Connect to Ethernet or Token Ring Networks to
	configure the Speed and Source Routing settings for your
	environment.
NOTE
	Your Document Centre now has DHCP, LPR, and NetBIOS over
	the IP protocol enabled by default. If your DHCP server will
	provide host name, IP address, Gateway address, and Subnet Mask,
	the Document Centre TCP/IP information will be configured on
	initial boot. This means that if you have configured your DHCP
	server with the desired information, you may go right to the
	heading in this section entitled Go to a Workstation and....
	For information on how your printer can connect to a BOOTP
	server, or a RARP server to be assigned an IP address dynamically,
	refer to the section in this document entitled Dynamic/Static IP
	Addresses & WINS. Information in regards to static IP address
	configuration may be found within that section as well.

OS/2 (TCP/IP)	Networks
12.

Xerox Document Centre System Administration Guide Page 12 - 1