Xerox 490 ST, 480 ST manual Set Up Options, Set up scanning

Set Up Options

There are two procedures that can be used to successfully set up scanning. Read the information below and choose the procedure that you will use to complete the installation:

•Set up scanning

To complete the native implementation of scanning for your

NetWare environment, go to the section of this chapter titled Set

Up Scanning now.

•Use Xerox CentreWare Internet Services

Xerox’s CentreWare Internet Services is accessed through the embedded HTTP server on the Document Centre that allows System Administrators and users to configure scan settings. This is accomplished by using an Internet browser such as NetScape (version 3.x or later) or Microsoft Internet Explorer (version 4.x or later).

Using Internet Services, you can:

•Create new scan templates.

•Update existing scan templates.

•Modify scan configurations (including document repository locations), enable and disable Confirmation Sheets, and change Filing Protocols.

•Enable Multi-Page TIFF, which will create a single TIFF file for a multi-page document, instead of one TIFF file for each page.

Output Image Quality

•Multi-Page TIFF can be enabled using Xerox CentreWare Internet Services. When Multi-Page TIFF is enabled, a sin- gle TIFF file will be created for a multi-page document. This single TIFF file will contain all the pages of the docu- ment. An .XSM folder is not created when scanning in the Multi-Page TIFF mode. A single TIFF file and a log file (.xst) are stored in the repository for each multi-page docu- ment that is scanned.

Page 20 - 16 Xerox Document Centre System Administration Guide