Xerox 490 ST, 480 ST manual Configure your printer, Connectivity and Network Setup button

Before You Start

Your Document Centre device and workstation(s) must be connected to a network which has the TCP/IP protocol enabled.

This procedure assumes you have a general knowledge of your network type and the operation of your Web Browser software, and that your Document Centre printer has been assigned all TCP/IP information.

Configure your printer

NOTE	To use Internet Services on the Document Centre
	490/480/470/460 ST, this feature must be enabled.
	The procedure below is supplied to enable this feature
	or disable it if you do not wish to use Internet
	Services.
	1.	Connect your Document Centre to the network
		with the appropriate cabling.
	2.	Go to the Document Centre control panel.
	3.	Enter the Tools pathway.
		a)	Press the Access ( or	) button.
		b)	On the keypad enter 1111 or the current
			password. Press the Enter button when
			finished. The Touch Screen will be used
			for the remainder of the data entry, unless
			instructed otherwise.
		c)	Press the Go to Tools button.
	4.	Enable the Network Protocol.
		a)	Wait for the screen to refresh and press the
			Connectivity and Network Setup button.

Page 16 - 4 Xerox Document Centre System Administration Guide