Xerox 480 ST, 490 ST manual Internet Services Quick Install Card to configure your

Before You Start

NOTE	Your Document Centre now has DHCP, LPR, and NetBIOS over
	the IP protocol enabled by default. If your DHCP server will
	provide host name, IP address, Gateway address, and Subnet Mask,
	the Document Centre TCP/IP information will be configured on
	initial boot.
	Your printer and your network accounting solution software or
	server must be connected to a network which has the TCP/IP
	protocol enabled and all TCP/IP information such as hostname,
	Default Gateway and Broadcast address have been set.
	Your Document Centre and network accounting solution server
	should be assigned TCP/IP addresses and the HTTP protocol must
	have been enabled at your Document Centre. If necessary, refer to
	the Internet Services Quick Install Card to configure your
	Document Centre in this manner.
	If Dynamic TCP/IP addressing must be used, be sure to set lease
	times long enough to allow for normal maintenenace shutdowns. If
	your Document Centre appears to have stopped communicating
	with the network accounting solution when Dynamic Addressing is
	in use, check the TCP/IP settings to be sure they have not changed.
	As a quick test to verify all the requirements have been met, start the
	Web Browser from your network accounting solution server and
	enter the IP address of the Document Centre to see if you can
	communicate with it using the HTTP protocol. If the Browser
	connects and you can see the “Home Page” proceed to the next
	section entitled Go to the Document Centre and...

18. Network Accounting

Xerox Document Centre System Administration Guide Page 18 - 3