Xerox 490 ST How to set the Ring Speed and Source Routing, Press the Token Ring Settings button

How to set the Ring Speed and Source Routing

1.Enter the Tools pathway

a)Press the Access ( or ) button.

b)On the keypad enter 1111 or the current password. Press the Enter button when finished. The Touch Screen will be used for the remainder of the data entry, unless instructed otherwise.

c)Press the Go to Tools button.

2.Set or Change the Ring Speed or Source Routing.

a)Wait for the screen to refresh and press the Connectivity and Network Setup button.

b)Wait for the screen to refresh and press the Physical Media button.

c)Press the Token Ring button.

d)Press the Token Ring Settings button.

e)Select the desired Ring Speed (4 Megabits or 16 Mega- bits per second).

f)Select the desired method of Source Routing (Single Route Broadcast or All Route Broadcast).

g)When finished with your changes press Save.

3.Press the Exit Tools button.

4.Wait a MINIMUM of 7 minutes for the printer to reset. The Network Controller is being reset and initializing with the new setup. When complete a Configuration Report will print.

a)Obtain the Configuration Report page from your printer and verify that your Token Ring Settings have been retained.

5.Connect your Document Centre to the network with the appropriate cabling.

Page 2 - 4 Xerox Document Centre System Administration Guide