Xerox 490 ST How to set the Ethernet Speed, Network Setup button, Speed 10Mbps, 100Mbps, or Auto

How to set the Ethernet Speed

1.Enter the Tools pathway

		a)	Press the Access (	or	) button.
		b)	On the keypad enter 1111 or the current password. Press
			the Enter button when finished. The Touch Screen will
			be used for the remainder of the data entry, unless
			instructed otherwise.
		c)	Press the Go to Tools button.
	2.	Set or Change the Network Connection Speed.
		a)	Wait for the screen to refresh and press the Connectivity
			and Network Setup button.
		b)	Wait for the screen to refresh and press the Physical
			Media button.
		c)	Press the Ethernet button.(If available.)
NOTE
	Auto-Sensing hubs may not arbitrate correctly with the Document
	Centre when Auto is selected. If your hubs/concentrators support
	the 100BaseT speed it is recommended you select 100Mbps in
	Step d below. (Be sure your Ethernet cable is Category 5)
		d)	Select the desired	Speed 10Mbps, 100Mbps, or Auto.
		e)	When finished with your changes press Save.
	3.	Press the Exit Tools button.
	4.	Wait a MINIMUM of 7 minutes for the printer to reset. The
		Network Controller is being reset and initializing with the
		new setup. When complete a Configuration Report will print.
		a)	Obtain the Configuration Report page from your
			printer and verify that your settings have been retained.
	5.	Connect your Document Centre to the network with the
		appropriate cabling.

Page 2 - 2 Xerox Document Centre System Administration Guide