Xerox 480 ST, 490 ST Windows 2000 LPR and IPP Printing, Entitled Go to the Server/Workstation

10.Windows 2000 LPR and IPP Printing

Before you Start

NOTE	Your Document Centre now has DHCP, LPR, and NetBIOS over
	the IP protocol enabled by default. If your DHCP server will
	provide host name, IP address, Gateway address, and Subnet Mask,
	the Document Centre TCP/IP information will be configured on
	initial boot. This means that if you have configured your DHCP
	server with the desired information, you may connect your
	Document Centre to your network and go right to the section
	entitled Go to the Server/Workstation and....
	For information on how your printer can connect to a BOOTP
	server, or a RARP server to be assigned an IP address dynamically,
	refer to the chapter in this document entitled Dynamic/Static IP
	Addresses & WINS. Information in regards to static IP address
	configuration may be found within that section as well.
	To enable 100BaseT or a Token Ring interface, refer to Chapter 2
	How to Connect to Ethernet or Token Ring Networks to
	configure the Speed and Source Routing settings for your
	environment.

Windows 2000 LPR	and IPP Printing
10.

Xerox Document Centre System Administration Guide Page 10 - 1