Xerox 490 ST, 480 ST manual How to Use this Document, Document Centre Reference Guide

How to Use this Document

This document has been arranged to get the printer set up on your network quickly and with minimum reading.

1.Before connecting network cabling to the Document Centre device, perform the procedure contained in this document entitled How to Connect to Ethernet / Token Ring Networks.

2.For Dynamic TCP/IP addressing refer to the section entitled Dynamic/Static IP Addresses and WINS.

3.Review the Table of Contents in this document. Find the network operating system (NOS) or protocol, which pertains to your network.

4.Go to the page indicated and perform the procedure(s).

5.Once you are finished it is recommended you print a test page.

6.Check the print job for print quality. If print quality problems exist, use the Problem Solving section of the Reference Guide to correct the problem.

7.If your print job DID NOT print, see the Troubleshooting section for your operating system in this document to correct the problem.

8.Once your Document Centre is installed and printing, you can repeat these steps to enable your printer to print with additional protocols or network operating systems.

NOTE	For detailed safety information about this product refer to the
	Document Centre Reference Guide.

Page 1 - 2 Xerox Document Centre System Administration Guide