Xerox 480 ST, 490 ST manual Before You Connect to a Token Ring Network

Before You Connect to a Token Ring Network

	If your printer is equipped with a Token Ring interface, to avoid
	problems with your network you must configure the correct Ring
	Speed and Source Routing settings for your environment prior to
	connecting the printer to your network.
	The default settings for the Ring speed and Source Routing are
	16Mbps and None respectively. If you do not need to change these
	then you do not need to read any further in this chapter.
NOTE
	As with any other Token Ring device, connecting the Document
	Centre Token Ring card to your network while it is set at the
	incorrect Ring Speed can cause severe problems on your network.

Before you connect the printer to your network, perform the procedure on the next page entitled How to set the Ring Speed and Source Routing.

Connect to	Token Ring
2. How to	Ethernet or

Xerox Document Centre System Administration Guide Page 2 - 3