Xerox 480 ST, 490 ST manual Port 9100 Printing

22. Port 9100 Printing

	Introduction
	Your Document Centre supports printing from a variety of operating
	systems that support TCP/IP and now supports Port 9100 (RAW)
	printing, including Linux and Windows 2000.
NOTE
	Your Document Centre now has DHCP, LPR, and NetBIOS over
	the IP protocol enabled by default. If your DHCP server will
	provide host name, IP address, Gateway address, and Subnet Mask,
	the Document Centre TCP/IP information will be configured on
	initial boot.
	Your Document Centre has DHCP enabled by default. If your
	DHCP server is configured with the TCP/IP information for the
	Document Centre, you should Skip Steps 5 and 6 in this procedure
	and go to Step 7 to enable Port 9100 printing. If you wish to
	configure your TCP/IP information statically, complete ALL Steps
	on the following pages.

22. Port 9100 Printing

Xerox Document Centre System Administration Guide Page 22 - 1