Kenwood KDV-MP3346, KDV-MP3346M ˆOther settings before, operations, ˆPrepare the remote, controller (RC-DV350), 5Adjust the minute, 6Finish the procedure, 1Turn the unit to standby state

5Adjust the minute.

1 : 00

Press 4 to return to the hour adjustment.

6Finish the procedure.

[Hold]

While in clock display screen, press and hold SCRL DISP will enter <CLOCK ADJ> setting directly. Perform steps 4 and 5 to adjust the hour and minute.

ˆOther settings before

operations

Before using this unit for the first time, make the following settings for optimum performance.

1Turn the unit to standby state.

2Enter Function Control settings.

3Select “INIT SETUP.”

ˆPrepare the remote

controller (RC-DV350)

Insert the batteries into the remote controller by matching the polarity (+ and –) correctly.

AAA/R03

If the range or effectiveness of the remote control decreases, replace both batteries.

Caution:

•Danger of explosion if battery is incorrectly replaced. Replace only with the same or equivalent type.

•Battery shall not be exposed to excessive heat such as sunshine, fire, or the like.

4Turn the control knob to make a selection, then press to confirm.

See table on page 6 for selection.

5Finish the procedure.

[Hold]

ENGLISH 5