PROBLEM | POSSIBLE CAUSE | SOLUTION |
The display shows that the changer is being played, but no sound can be heard.
The computer chip in the unit is not functioning normally. | Press the reset button on the unit (see p. 5). |
The specified track will not play.
Random play or magazine random play has been selected.
Turn off random play or magazine random play.
Track repeat, disc repeat, track | The setting is not canceled. | The settings for these functions remain on until the |
scan, random play, and |
| setting to off or the disc ejected, even if the power is |
magazine random play start by |
| turned off or the source changed. |
themselves. |
|
|
|
|
|
Cannot play | Finalization processing is not being conducted for CD- | Conduct finalization processing with CD recorder. |
|
| |
|
|
|
| A | Use a CD changer compatible with |
|
| |
|
|
|
Can’t remove disc. | The cause is that more than 10 minutes has elapsed | The disc can only be removed within 10 minutes of the |
| since the vehicle ACC switch was turned OFF. | ACC switch being turned OFF. If more than 10 minutes |
|
| has elapsed, turn the ACC switch ON again and press |
|
| the Eject button. |
"AUX" is displayed without achieving External disc control mode.
Set the switch to "N" side. | |
|
|
Unsupported disc changer is connected. | Connect the supported disc changer. (see page 4) |
If the following situations, consult your nearest service center:
•Even though the disc changer is connected, the Disc Changer Mode is not on, with "AUX" showing in the display during the Changer Mode.
•Even though no device
— 29 —