General features

English

"Bass" : Adjust the bass level.

Setting values: - 8 – + 8

"Mid" : Adjust the middle level.

Setting values: - 8 – + 8

NOTE

The System Q function changes the values of the following sound quality parameters:

Bass centre frequency, bass level, bass quality factor, bass extend, middle centre frequency, middle level, middle quality factor, treble centre frequency, and treble level.

Their setting values are different depending on the setting of the speaker setting mode.

"Treble" : Adjust the treble level.

Setting values: - 8 – + 8

"Balance" : Adjust the balance level. Setting values: Left 15 – Right 15

"Fader" : Adjust the fader level. Setting values: Rear 15 – Front 15

"V OFFSET" : Set the sound level of the each source selected by adjusting the level difference between the basic sound level and the required level.

Setting values: - 8 – ± 0

"SYS-Q" : < System Q > Recalling the kenwood preset sound setting

Press the preset buttons (#1-6).

Settings:#1;Flat (‘SYS-Q Flat”), #2;Rock (‘SYS-Q Rock”), #3;Top 40 (‘SYS-Q Top40”), #4;Pops (‘SYS-Q Pops”), #5;Jazz (‘SYS-Q Jazz”), #6;Easy (‘SYS-Q Easy”)

Speaker Setting

This function allows you to adjust the setting that is recalled with the System Q, according to types of speakers.

1Press the SRC button repeatedly to select the standby mode. "ALL OFF" is displayed when the standby mode is selected.

2Press the AUD button to enter the speaker setting mode.

3Press either the 4 or ¢ button to select the type of speaker. The setting switches as follows.

Off ("SP OFF") / For the OEM speaker ("SP OEM") / For 6/6x9 in. speaker ("SP 6/6x9inch") / For 5/4 in. speaker ("SP 5/4inch")

4Press the AUD button to end the speaker setting mode.

NOTE

Speaker setting function allows for tuning of bass, middle and treble

Theft Deterrent Faceplate

The faceplate of the unit can be detached and taken with you, helping to deter theft.

Projections

Release button

Grooves

— 8 —