troubleshooting
solution
solution
problem
●The whisk or
●Adjust the height using the spanner provided. Here’s how:
1Unplug the appliance.
2Raise the mixer head and insert the whisk or beater.
3Lower the mixer head. If the clearance needs to be adjusted, raise the mixer head and remove the tool. Ideally the whisk and
| almost touching the bottom of the bowl . |
|
4 | Using the spanner provided loosen the nut | sufficiently to allow |
| adjustment of the shaft . To lower the tool closer to the bottom of the | |
| bowl, turn the shaft | |
| of the bowl turn the shaft clockwise. |
|
5 |
| |
6Fit the tool to the mixer and lower the mixer head. (Check its position see points above).
7Repeat the above steps as necessary until the tool is set correctly. Once this is acheived tighten the nut securely.
dough hook - this tool is set at the factory and should require no adjustment.
problem
●The mixer stops during operation.
●Your mixer is fitted with an overload protection device and will stop if overloaded to protect the machine. If this happens, switch off and unplug the mixer. Remove some of the ingredients to reduce the load, and allow the mixer to stand for a few minutes. Plug in and reselect the speed. If the mixer does not restart immediately allow to stand for additional time.
to fit and use your splashguard
1Raise the mixer head until it locks.
2 Fit the bowl onto the base.
3 | Push the splashguard onto the underside of the mixer head | until fully |
| located. The hinged section should be positioned as shown. |
|
4 | Insert required tool. |
|
5Lower the mixer head.
●During mixing, ingredients can be added directly to the bowl via the
hinged section of the splashguard | . |
●You do not need to remove the splashguard to change tools.
6Remove the splashguard by raising the mixer head and sliding it down.
7
