Troubleshooting Guide
Some functions of this unit may be disabled by some settings made on this unit.
! • Cannot set up the subwoofer.• Cannot set up the low pass filter.• No output from the subwoofer.▲ • <Subwoofer output> of <Basic Operation> (page 6) is not set to On.
! • Cannot set up the subwoofer.
• Cannot set up the High Pass Filter.• Cannot set up the Fader.• No Audio control effect on AUX.• Cannot set up the subwoofer position of Manual position setting.▲ • <Subwoofer output> of <Basic Operation> (page 6) is not set to On.
• The Dual zone function is enabled. ☞ <Basic Operation> (page 6)
! • Cannot set up the subwoofer phase.▲ The Low Pass Filter is set to Through. ☞ <Audio Setup> (page 14)
!• Cannot select the output destination of the subsource in the Dual zone.•Cannot adjust the volume of the rear speakers. ▲ The Dual zone function is disabled. ☞<Basic
Operation> (page 6)
What might seem to be a malfunction in your unit may just be the result of slight misoperation or miswiring. Before calling service, first check the following table for possible problems.
General?The Touch Sensor Tone does not sound.✔The preout jack is being used.
☞The Touch Sensor Tone cannot be output from the preout jack.
Tuner source?Radio reception is poor.✔ The car antenna is not extended. ☞ Pull the antenna out all the way.
Audio file source?The sound skips when an Audio file is being played.✔ The recording condition is bad.
☞ Record the media again or use another media.
26