Kenwood KMX50 manual to fit and use your splashguard, troubleshooting, problem

solution

Note:

solution

to fit and use your splashguard

1Raise the mixer head until it locks.

2Fit the bowl onto the base.

3Push the splashguard onto the underside of the mixer head until fully located. The hinged section should be positioned as shown.

4Insert required tool.

5Lower the mixer head.

●During mixing, ingredients can be added directly to the bowl via

the hinged section of the splashguard .

●You do not need to remove the splashguard to change tools.

6Remove the splashguard by raising the mixer head and sliding it down.

troubleshooting

problem

●The whisk or K-beater knocks against the bottom of the bowl or isn’t reaching the ingredients in the bottom of the bowl.

●Adjust the height. Here’s how:

1With the mixer switched off, insert the beater or whisk and lower the mixer head. Check the clearance between the tool and

the bottom of the bowl . Ideally the tool should be almost touching the bottom of the bowl.

2If the clearance needs to be adjusted, raise the mixer head and remove the tool.

3Using a suitable spanner loosen the nut sufficiently to allow

adjustment of the shaft . To lower the tool closer to the bottom of the bowl, turn the tool shaft anti-clockwise.

To raise the tool away from the bottom of the bowl turn the shaft clockwise.

4Tighten the nut.

5Fit the tool to the mixer and lower the mixer head. Check its position (see point 1).

6Repeat the above steps as necessary until the tool is set

correctly. Once this is achieved tighten the nut securely. ● No adjustment of the dough hook is necessary.

problem

●The mixer stops during operation.

● If for any reason power to the mixer is interrrupted and the machine stops working, turn the speed switch to the off position, wait a few seconds and then re-select the speed. The mixer should resume operating straight away.

5