Setting up the system
PRE OUT connections
This receiver has additional preout jacks. These can be used for various purposes, but will need to be connected to an external power
amplifier as shown in the example below. Connecting a speaker cord directly to a PRE OUT jack will not produce any sound from the speaker.
Be sure to set one of the SPEAKERS keys (either A or B) to the ON position when using the PRE OUT jacks.
PRE OUT
| SURROUND | CENTER |
|
|
| Power amp | Center Speaker |
Surround | Power amp | SUB | Powered |
Speakers |
| WOOFER | |
|
| Subwoofer | |
|
|
|
1 3
Preparations
Preparing the remote control
Loading the batteries
1 Remove the cover. | 2 Insert the batteries. | 3 Close the cover. |
• Insert four
| 1. The supplied batteries may have shorter lives than ordinary batteries due to use during operation checks. | |
Notes | 2. Replace all four batteries with new ones when you notice a shortening of the distance from which the remote control will operate or if the | |
remote control blinks 5 times when you push a key. The remote control is designed to retain set up codes in memory while you change | ||
| ||
| batteries. Failure to change batteries after receiving the 5 blink battery warning signal may cause all the memory to be lost |
3.Placing the remote sensor in direct sunlight, or in direct light from a high frequency fluorescent lamp may cause a malfunction. In such a case, change the location of the system installation to prevent malfunction.
Operating distance
This remote control has two IR emitters: one to send commands in a straight line over long distances, allowing you to control the receiver and your other components from farther away; and one for wide dispersion of commands in a closer proximity, for near- field operation even when the remote control is not pointed directly at the respective component.
Remote sensor
6 m
10 m
30˚ 30˚