Getting the most from your remote control

KR-V9090/8090 (En/T)

44 5Hold your remote to the speaker portion of your telephone.

• For each setup code the operator can supply a setup code number. Should you ever need to change your input configuration, this number can be used. Please record for your future reference. If for some reason this information is lost, see "Checking a setup code" in the "Setup code correlation" section for further information.

Code selection after mode download

After successful completion of the download, step 5 above, the remote control automatically enters a special set-up mode which works as described below.

1Select the component for which you want to register the information downloaded above.

Press the VIDEO, AUDIO, or TV key repeatedly to select the desired component.

AUDIO

VIDEOTV

VIDEO key

AUDIO key

TV key

 

 

1 VIDEO1 (VCR 1)

 

 

1 CD (CD)

 

 

1 TV1

 

 

2 VIDEO2 (VCR 2)

 

 

2 TAPE/MD

 

 

2 TV2

 

 

3 VIDEO3 (LD)

 

 

(TAPE)

 

 

3 CABLE

 

 

 

 

 

 

3PHONO

•Example 1 : To register a code at the component connected to the VIDEO 1 jacks, select "VIDEO 1 (VCR)".

Perform each of the following steps within 5 seconds.

Control Remote

2Press a numeric key.

MENU THEME FAV

1 2 3

TV/SAT/VID INFO

ALT AUD

4 5 6

+100 REPEAT RANDOM

7 8 9

DISPLAY

0

•Press the 1 key to output the POWER code of the first component on your list in step 1 of the previous page. Continue to push buttons 2 through 9 (and 0) until the component you want to register turns on.

•Though the FutureSet memory in your remote control is quite large, only 10 setup POWER codes can be put on the 10 keypad at any one time. If you require a larger download, the standard setup procedure can be used. See "Registering setup codes for other components", your customer service representative can supply you with the downloaded setup code numbers.

3

4

Repeat steps 1 and 2 to register all of the downloaded information.

Hold down the ENT key until the backlight flashes twice.

•The setup code for the last POWER code to be sent in step 2 is automatically registered at the location selected in step 1.

•At this time, the remote exits the special set-up mode and returns to its normal operation mode.

ENT