Installation

■Removing the hard rubber frame

1Engage the catch pins on the removal tool and remove the two locks on the lower level.

Lower the frame and pull it forward as shown in the figure.

Catch

Lock

Accessory2

Removal tool

2When the lower level is removed, remove the upper two loca- tions.

NOTE

The frame can be removed from the top side in the same man- ner.

■Removing the Unit

1Refer to the section “Removing the hard rubber frame” and then remove the hard rubber frame.

2Remove the Hex-head screw with integral washer (M4⋅8) on the back panel.

3Insert the two removal tools deeply into the slots on each side, as shown.

Accessory3

Catch facing up

4 Lower the removal tool toward the bottom, and pull out the unit halfway whilst pressing towards the inside.

2CAUTION

Be careful to avoid injury from the catch pins on the removal tool.

5 Pull the unit all the way out with your hands, being careful not to drop it.

— 15 —